| Gallery, Projects and General > The Design Shop |
| D1-4 Adapter |
| << < (5/5) |
| Swarfing:
Dave that will be great if you could send them to me, my emails on the PM i sent you. The camlock pins come today which gives me a better idea of how the back plate will fit against the nose and with the sizes the guys have given (40mm) means i should only be an extra 10mm (5/8") further out which is better than i expected. i will also be able to use both bolt circles to secure the nose as well. Dave is there any reason why you feel speed should be an issue? thanks |
| Davo J:
Hi Bob, Unless I am reading it wrong, part number 178 (ECCENTRIC SHAFT) is the cam lock in the listing below. I remember going through all the part lists for the lathes and one of them had them for $5 something. I tried looking now but the grizzly site is going slow for me. 175 P4002175 LOCK PIN $1.75 176 P4002176 SPRING 6 X 4 X 22 $1.75 177 P4002177 SCREW M8 X 16 $1.75 178 P4002178 ECCENTRIC SHAFT $7.00 http://www.grizzly.com/products/G4002/parts/6 Swarfing, I think you are getting Bob and I mixed up, as it was him that mentioned speed. Dave |
| Davo J:
Hi again Bob, I re started the computer and it's working fine now so I had another look This is from the gun smith lathe parts list http://www.grizzly.com/products/G0709/parts/10 108 P07090108 CAM LOCK $7.00 111 PCAP02M CAP SCREW M6-1 X 20 $1.00 112 P07090112 COMPRESSION SPRING $1.75 Then you get this from the 4016 parts http://www.grizzly.com/products/G9036/parts/14 P4016045 SPRING .6 X 4 X 16 $4.25 P4016046 PIN 6MM $7.00 P4016047 CAMLOCK $41.50 I cant see why the other one is so expensive, because I thought all D1-4 components where made to the same specifications. Dave |
| Swarfing:
LOL! Dave sorry dreaded typo and Bob if you could send me the drawings i would appreciate it. Thanks |
| Navigation |
| Message Index |
| Previous page |