| The Shop > Metal Stuff |
| A Bit Over Engineered |
| << < (2/3) > >> |
| PekkaNF:
I don't see all the workking angles so my concern might be ungounded. If ground is all treebark or such that might work. On rake? I have seen those spikes are springy things, like some coils on the upper end to give in when you run into obstacle. Those strong steel rods might rip off or bend. Also, as stated before, I would consider some sort of slipjoint or such on the hitch to allow some slack after a snatch. PekkaNF |
| doubleboost:
The tow hitch is below the axle centre height so the quad will be poulled down There is a 6 inch layer of bark on top of a membrane the spikes will only go in 4 inches We will find out how it works at the weekend Thanks for your concerns Regards John |
| doubleboost:
It workes fine :) :) :) :) Hooked it up to the quad set the height great result first time :) :) :) Click the last picture All in all a very satisfying project (i even made a few quid to spend on tooling) John |
| Stilldrillin:
That's a crackin' piece of kit John! :clap: :clap: I knew it would work, first time out...... :thumbup: David D |
| sbwhart:
Fine bit of work :thumbup: You'll be getting a few orders for those when the word gets round. :D Stew |
| Navigation |
| Message Index |
| Next page |
| Previous page |