| The Shop > Tools |
| Siege X3 Supper Mill |
| (1/3) > >> |
| sbwhart:
Hi Chaps I'm in the market for a new Mill I've more or less settled for a Seige X3 supper, it will just about fit in my shop with a bit of re-arranging, and I would be interested in any comments you may have good or bad on this machine or alternative machines of the size. Any details on Modifications or additional you may have carried out, particularly adding a DRO or power feed would be aoriciated. Cheers :wave: Stew |
| cedge:
Stew Own one and love it. It's a lot of machine for the size. Nice large work envelope and the power to take a pretty heavy cut without complaint. DRO's were an easy install and the factory power feed is a monster. Have yet to find any real negatives so far. Steve |
| sbwhart:
Hi Steve Thanks for your comments it's always comforting to have feed back from people who have used the Kit. Thanks again :wave: Stew |
| cedge:
Stew One item... you'll need a couple or 3 stout friends to help get it on the bench. That sucker is HEAVY. Steve |
| sbwhart:
hi Steve Thanks for the warning, with my small shop I doubt I'd get three guys inside it, I was planning on stripping the machine down out side, giving it a clean, and building it up piece by piece in the shop :borg:, this is what I did with my 3 in 1, do you think it will be posible to do this with the Mill. Cheers :wave: Stew |
| Navigation |
| Message Index |
| Next page |