Gallery, Projects and General > Project Logs |
Concrete machine bench moved into the w'shop..... but...... |
<< < (2/4) > >> |
tumutbound:
--- Quote from: John Hill on August 17, 2011, 12:59:37 AM --- Mill in position and look at all the clear space in the workshop! --- End quote --- Clear space in a workshop? I find that hard to believe. Must be Photoshopped! |
John Hill:
--- Quote from: tumutbound on August 17, 2011, 03:55:32 AM --- --- Quote from: John Hill on August 17, 2011, 12:59:37 AM --- Mill in position and look at all the clear space in the workshop! --- End quote --- Clear space in a workshop? I find that hard to believe. Must be Photoshopped! --- End quote --- Nah, just havent bought enough stuff yet! |
allanchrister:
John, Hope you don't mind me asking, but I'm sure others want to know as well - did you design it, and how much did it cost???? |
John Hill:
--- Quote from: allanchrister on August 17, 2011, 11:40:09 AM ---John, Hope you don't mind me asking, but I'm sure others want to know as well - did you design it, and how much did it cost???? --- End quote --- Total project will be about 900 Euro. I had a basic shape and size and the concrete casting people did the actual design, |
Davo J:
Was delivery and installation all a part of that price John? Also are you going to put some type of cupboards under it to use up the space? I think the off set studs that we mentioned on the other forum would would for the miscalculated holes, you could even leave a flange in the middle to rest against the table top. Once in, the grout would cover them up and you would never know they where their. It would also save drilling and messing with the bench for 4.5mm. Dave |
Navigation |
Message Index |
Next page |
Previous page |