Gallery, Projects and General > Project Logs
Home built die filer
<< < (11/13) > >>
DaveH:
Al,

Very well made from the castings to the finished article. :thumbup: :clap:

An excellent post, very well presented, well writen and photographed :clap: :clap: :clap:
 :beer:
DaveH
doubleboost:
Very nice :clap: :clap: :clap:
Thank you for a well photographed & written project log :thumbup: :thumbup:
Other than mining the ore yourself this is poropper scratch built :bugeye: :bugeye:
I am sure you will find lots of uses for your die filer :drool: :drool:
Well done
John
arnoldb:
Really good job Al  :clap: :clap:

Will definitely save a bit of wear on the fingers  :)

 :beer:, Arnold
danstir4:
Great project and I was amazed at the versatility of your skills!
CallMeAl:
Thanks everyone for the nice comments.  I'm glad that I could contribute some thing to the form after watching all the wonderful builds that have been presented here.

Anzaniste:  Yes the fly cutter was made from the plan in Harvey's book.  One the first tools I made.  I use it every once in a while when I need a wide cut.  I need to make a counter weight for when the arm is extended out too far. Also, I haven't found the perfect grind on the tool bit yet.  As to the speed at which the project progressed, you need to figure in the week and a half of building the pattern that I didn't show this was by far the most time consuming part.

Bernd: I mounted it on my grinder stand to share the work light and to save space.  It vibrates a little, but it is not the bad for how much it will be used.  I will experiment with the variable pulley to find a speed that lessens the vibration but works fast enough to actually get some metal removal.
Navigation
Message Index
Next page
Previous page

Go to full version