Gallery, Projects and General > Neat Stuff
Micro DRO made from tyre tread depth gauge
John Rudd:
Mine arrived today...
Runs off a 3v CR20xx coin cell battery...Shame it wont accept the data plug on my remote readout...So cant tell if its compatible or not..like my scales are..Something to work madmodder I guess :dremel:
Pete.:
These reader heads DO work with the cheap 6" digital caliper scales, coz I've tested it. Can't fit the boards onto the metal slides of the calipers though without milling a step in each side of the PCB.
saw:
I'll got my today, but I am not shure how to build it. I have a minilathe and it don't looks exactly as the project show. :scratch:
Here is a pic of my lathe.
I need a good advice how I should do. ::)
ksor:
I think the idea with the magnets is good - I'll use mine - when I get them - for both my mill and lathe - then the idea with the magnets is good, I think !
With the magnets you can place it whereever you want on then mill or the lathe - if it's iron of cause.
I'll make mine with magnets I'm sure.
ksor:
Now I got mine in hand - thanks JohnC !
I dicovered a small hatch opposite the battery hatch - looke like 2 wires could be solded on the pcb !
Do some of you know what this is good for ?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version