Gallery, Projects and General > Gallery

More stuff

(1/2) > >>

mechman48:
 :wave:
Some more pics.

I have dug out the trial version of my taper turning attachment, this needs a couple more mods to it to finish it off, i.e. marking fiducal lines to define the taper being cut, a more positive return screw action 'n stuff like that. As always I have used old drill MT's where possible & being commercially produced are as accurate as can be.The ball nose (from old ball bearing) was silver soldered on to provide some lateral movement in non protected centers (methoughts  :scratch:) still have yet to prove it's practicality in  tests  :dremel:.
 






Clamp type knurling tool, all the knurls in my pics were created using this






Will post some more later (hope some of you are not getting too bored) :coffee:
bfn

andyf:

--- Quote from: mechman48 on July 25, 2011, 03:44:47 PM ---..... Will post some more later (hope some of you are not getting too bored) :coffee:
bfn


--- End quote ---

Bored? No way. WE LOVE PICS :D

doubleboost:
Thanks for posting
The taper turning centre looks to be a handy bit of kit
John

saw:
Nice work  :thumbup:

Topos:
Gratitude for clever device is never boring!   

Thanks. :beer:

Navigation

[0] Message Index

[#] Next page