| The Shop > Our Shop |
| Concrete machine bench? |
| << < (2/8) > >> |
| srm_92000:
Hi, My dad made a bench for his wood lathe as basically just a wooden box (fairly thick top piece) with legs, then, when all in place filled it with about 5or more bags of sand - doesn't move anywhere fast! but you can always get it out if needed. Cheers Steve. |
| 75Plus:
--- Quote from: John Hill on July 01, 2011, 04:56:50 PM --- I will be pretty upset if it cracks! --- End quote --- I recently had 35 cu. yards of concrete poured for a driveway and parking area. The concrete guy assured me that there were 3 positives about concrete. 1. It will get hard. 2. No one will steal it. 3. IT WILL CRACK :bugeye: :med: Joe |
| owenh:
I made a concrete benchtop for my little atlas a few years ago, just built a form on the shop floor upside down with the holes for attaching the bits cast in place. I used bits of plastic water pipe. I finished it with automotive plastic body filler and painted it. i'm quite happy with it. |
| John Hill:
--- Quote from: 75Plus on July 01, 2011, 10:08:56 PM --- 3. IT WILL CRACK :bugeye: :med: Joe --- End quote --- I think you used the wrong contractor to pour your concrete. We use a lot of concrete around here, driveways, houses, boats, furniture and we dont expect it to crack. Driveways etc we put saw cuts in to prevent cracks. |
| PekkaNF:
--- Quote from: 75Plus on July 01, 2011, 10:08:56 PM ---3. IT WILL CRACK :bugeye: :med: Joe --- End quote --- NO it will not!. * You need correct amount of reinforcement, probably two meshes or what ever is that net made out of about 5-6 mm steel. You need spacers to place them to proper depth. Here you can find a plastic standoffs with varying height. * Proper mix of concrete (too much water and it WILL shrink and crack), cast right and then don't waddle with the surface until you get the water out. *Depending the air temperature, you may need to spray with water for a week and cover it with plastics to keep it from drying too fast. * You also want to design it to avoid wild cross section variation, different thicknesses will dry/cure different speed AND shrink different speed AND that generates the cracks. Therefore, you probably want to make base and top separate. Just my personal experience, I did need to find out basics of concrete when I did some home renovation. Pekka |
| Navigation |
| Message Index |
| Next page |
| Previous page |