Gallery, Projects and General > Gallery
My Tubing Bender
dickda1:
Beautiful job. :bow:
I am adding this to my project list (derived mostly from these forums).
Dick
allanchrister:
Looked at the square drive listing for the UK. Doesn't show Robertson square drive machine screws. Are they made??
Davo J:
Nice job and looks like it works great. :beer:
Dave
snub:
Thanks to all for your compliments and comments. It is much appreciated.
Regarding the length of the follow block, I found this old picture from DiAcro. Judging by the size of the guys hand in comparison to the size of the tubing, I would guess the tubing to be about 1/4" in diameter. Yet look at the length of the follow block. 6" or so? I'm just guessing.
Hobby-Machinist:
You did a great job on that- it looks a lot more sturdy than what you can buy!
Congratulations!
Nelson
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version