Gallery, Projects and General > Project Logs
A Cracker locomotive
<< < (16/21) > >>
saw:
This is so very intressting project, I just love it.  :) :clap: :clap:
DaveH:
Arnold,

Some very nice silver soldering on that gas tank - very nice gas tank. :clap:

Coming along very nicely, nicely posted as usual. :thumbup:

It is really going to look something special this cracker :clap: :clap: :clap:
 :beer:
DaveH
Stilldrillin:
I love the way you think through, and develop ways around problems Arnold!  :thumbup:

Love how this is developing......  :clap: :clap:  :D

David D

arnoldb:
Benni, Dave, David - Many thanks Gents  :beer:

I had two days of leave from work; unfortunately not for shop, but to attend to some matters relating to government red tape...
At least I bought a good quality pressure gauge yesterday - at very good discount from one of my regular suppliers.  I'm finding that a lot of the suppliers that up to a year or so ago treated me a bit reservedly has nicely thawed; where initially discount and a bit of natter was taboo, that's run of the mill now.  Got the gauge for less than half the shelf price!

This afternoon I got a bit of shop time.

Started by turning down and single-point threading a bit of 8mm hex brass to the same dimensions and thread as the gas filler valve:


Then parted off a section, flipped it in the chuck, drilled through at 2mm and then drilled and tapped it M6x0.5 to fit existing adapters for my pressure testing kit.  Ended up with this:


It needed an O ring - so I added that:


Then I set up for testing - replacing my 1000kpa gauge with the new 4000kpa gauge.  The gas tank was filled with water - though not completely.  It is so small that a bit of air in it is needed to allow at least some form of control from the pump; if there is a leak it won't be too much:


On the first pressure-up I took it to 3000kpa, but the pressure dropped rapidly.  On checking, I found water leaking around the valve spindle packing, so I just snuck up the packing nut a bit more.
Next pressure up:


I left it sitting for 20 minutes, and came back to find the pressure had dropped slightly:


The gas tank was bone dry, so I looked around to find the leak; i eventually found it on the regulator adapter where a droplet of water had formed on the connection - but all-in-all, I think it's safe to say the gas tank is up to scratch  :ddb: :ddb:

As a final test, I screwed in the gas filler and filled the tank with gas, then plonked it in the water to see if there was any gas escaping by looking for bubbles:

No bubbles appeared...  I also tested the regulator while under water; it is easy to control and get varying amounts of gas escaping.

Having done that lot, I treated myself  :D :D :


 :beer:, Arnold
sbwhart:
Good going with the pressure test Arnold I reckon you'll have this beauty in steam before long.

Stew
Navigation
Message Index
Next page
Previous page

Go to full version