Gallery, Projects and General > How do I??

Filling holes in cast iron castings.

<< < (2/2)

jim:
at work they just use some metal filler, pretty good colour match too!

kwackers:
It's quite old - I bought them at a club auction, could be early 80's...

I think some form of filler will be fine, unlike a cylinder it's entirely cosmetic so shouldn't be an issue. Just need a good colour match...

kvom:

--- Quote from: Jasonb on June 13, 2011, 10:44:48 AM ---Drill it out and loctite a tight fitting bit of CI into the hole.

Nearest looking filler is plastic paddings "plastic metal" this is like car body filler but has iron powder as the filler, JB weld is a bit too light a grey.

Jason

--- End quote ---

This

krv3000:
Hi all well i have yoused this stuf and its brill   

krv3000:
HI thats the web ad   www.devcon. com

Navigation

[0] Message Index

[*] Previous page

Go to full version