Gallery, Projects and General > How do I??

Milling Titanium

<< < (2/8) > >>

DaveH:
John S,
Cuts fine on the lathe, never drilled or tapped it.
Milling - seems I am doing something wrong.

How should I mill it.
I should point out I don't use any coolant, sometimes use some cutting fluid to help.
However nothing seemed to help when milling it.

DaveH

doubleboost:
It welds nice with tig  :D :D :D
I had some off cuts of pipe i used them on my diy gas turbine
Once welded it is hard  :( :( :(

DaveH:
Tim,
I have tried cabide engraving cutters .003" depth of cut with cutting fluid, without cutting fluid still didn't come out right. All rough and raggity.

Could I have the spindle speed too high, do you think?

 :beer:

DaveH

DaveH:
Doubleboost,

Hey, try to keep focused on the problem.  :wack:    :D :D :D


(I'm just pulling your leg)  :)

 :beer:

Dave

doubleboost:
You will have to pull harder than that  :D :D :D :D :D

Navigation

[0] Message Index

[#] Next page

[*] Previous page