| Gallery, Projects and General > How do I?? |
| Milling Titanium |
| << < (2/8) > >> |
| DaveH:
John S, Cuts fine on the lathe, never drilled or tapped it. Milling - seems I am doing something wrong. How should I mill it. I should point out I don't use any coolant, sometimes use some cutting fluid to help. However nothing seemed to help when milling it. DaveH |
| doubleboost:
It welds nice with tig :D :D :D I had some off cuts of pipe i used them on my diy gas turbine Once welded it is hard :( :( :( |
| DaveH:
Tim, I have tried cabide engraving cutters .003" depth of cut with cutting fluid, without cutting fluid still didn't come out right. All rough and raggity. Could I have the spindle speed too high, do you think? :beer: DaveH |
| DaveH:
Doubleboost, Hey, try to keep focused on the problem. :wack: :D :D :D (I'm just pulling your leg) :) :beer: Dave |
| doubleboost:
You will have to pull harder than that :D :D :D :D :D |
| Navigation |
| Message Index |
| Next page |
| Previous page |