Gallery, Projects and General > Project Logs

Big Marine Steam Engine

<< < (6/36) > >>

Stilldrillin:
That's going to be some engine John!  :bugeye:

You're putting a lot of good work into it......  :clap: :clap: :thumbup:

David D

Brass_Machine:
Nice work!

Eric

doubleboost:
Had a day off work (so i spent it working in the shop ) :loco: :loco:
Made a start on the con rod , i was going to machine it from soild but decided on a fabricated job




Finally a bit of stress relief

Shoild get it machined tomorrow
John

lordedmond:
How will the CI ring wear in the bronze cylinder ?

I have only used CI rings in CI cylinders , I do use 'O' rings in bronze or soft packing


Nice work BTW I am not criticising just asking as I am knocking up a triple expansion engine that uses a bronze block and bronze rings , I an thinking of using CI as i know it will work


Stuart

Mike Cole:
Very nice work, I am very inpressed with the crank. is this engine going in a boat when finished?


Mike

Navigation

[0] Message Index

[#] Next page

[*] Previous page