Gallery, Projects and General > Project Logs
Rizzo.......
Stilldrillin:
Time to start on another Orphan........ :thumbup:
You've seen the pics of this one before. It's called “Justine's” by James G Rizzo. Published in Engineering in Miniature 2004.
Said never to have run. :scratch:
Looks ok..... Been picked up too many times, by the transfer pipe. I can actually feel it blowing from the displacer joint, when the flywheel is turned. ::)
Nil clearance at the ends of displacer 3/4" stroke. (Bump, bump, bump..... ). ::) ::)
Stripped.......
Everything seemed ok. Don't like the glued in, displacer and cylinder plugs.....
It needed a better support for the pipe to displacer cylinder joint. So, I opened the socket to 6mm x 10mm deep, intending to fit a recessed, extended sleeve, to support the lower end of the pipe. Which was also araldited in place, only....... ::) ::) ::)
The displacer piston slid freely in the bore........ Didn't feel quite right........ :scratch:
The shaft slid out into my hand!!! It had let go from the displacer!!!!! :bugeye:
Nowt else to do, but heat it up to loosen the glue, and release the bearing end cap...... :bang:
Not a lot of location area. Might have worked better if the braze hadn't been faced off...... ::)
No penetration! It had only been held on by the brazing flux....... ::) ::)
Oh dear...... Is this the start of another “Robinson rebuild” saga? :doh:
Sheesh! :bang: :bang:
sbwhart:
--- Quote ---Oh dear...... Is this the start of another “Robinson rebuild” saga?
Sheesh!
--- End quote ---
Well you sorted the Robinson out Dave I'm shure you'll sort this little Italian job and have it ticking over like a Ferrari
:hammer: :hammer: :hammer: :hammer: :hammer:
Looking forward to your adventures.
Stew
lordedmond:
Looks like beauty was only skin deep in this case
the builder has ,looking at the pics made a nice job but let himself/herself down with the hidden bits
Stuart
NickG:
Nice looking engine, was it a non runner to start with then?
stirling lad:
the builder appears to have tried for a nice finish but seems to have cut corners on the bits that are'nt seen...show us how it should be done David.. :scratch:
...Mike..
Navigation
[0] Message Index
[#] Next page
Go to full version