The Breakroom > Resources

New Special X2 Mill

<< < (7/8) > >>

ketanswali:
Hi Chuck,

Sorry we didn't do one for the original X2. We may do one for the SX2P when we get some time. Broadly speaking, the head of the original X2 is similar to the C3 mini-lathe. The head of the SX2/P is similar to SC2/3 mini-lathe. I also think you might find a strip guide for the X2 on one of the mini-mill forums.

HS93:
I have had the X1 type base and I found if I got the Gibs set near enough used it a bit so it beds in and then check it you will fing it will nead nothing more than the  gibs re setting if you start scraping bits at this stage when it beds in you will have to do it again, I would  just bed it in , the bedways are ok when they leave the factory, just need a bit of setting the long bed ones magnify any bad gib setting I found as updated mine with an Arc long bed kit

Peter

HS93:

--- Quote from: DaveH on May 31, 2011, 09:22:24 AM ---
Yawellnofine,

What did you expect it's from Leicester -   The best place in the whole wide world :D :D :D

So what am I doing in South Africa it's sunny :D :D :D

 :ddb: :ddb: :ddb: :ddb: :ddb: :ddb: :ddb: :ddb: :ddb:

DaveH

--- End quote ---
 
Yep Leicester great place

http://www.bbc.co.uk/news/uk-england-leicestershire-13713798

DaveH:
Hi Peter,

Good job I left!! :D :D :D
 :beer:
DaveH

HS93:
I saw it on the BBC web site today and thought, I wonder what Dave H did befor he left Leicester, and is that the reason they are not ready ? :lol: :lol:

    :ddb: :ddb: Peter  :ddb: :ddb:
                                                                                                                     :nrocks:

                                                                                                           Sorry      :offtopic:

Navigation

[0] Message Index

[#] Next page

[*] Previous page