Gallery, Projects and General > How do I??
Mini Lathe Electrikery.......
andyf:
:thumbup: :thumbup: :thumbup:
It would be interesting to know how Dave BC gets on with fixing the old board, if he gets round to it.
Andy
Bluechip:
--- Quote from: andyf on May 27, 2011, 10:24:01 AM --- :thumbup: :thumbup: :thumbup:
It would be interesting to know how Dave BC gets on with fixing the old board, if he gets round to it.
Andy
--- End quote ---
Picking the dead board up tomorrow at Eastwood AFIAK.
Anyway ....
It's all very well his controller chirping up .... :clap:
My telly now has a 6" x 4" picture ... :( :(
And me toaster is taking 3 hours to dry a slice of bread ...
Dave BC
lordedmond:
good news
its good when a plan comes together with no release of more magic smoke
Andyf I bet its the motor not the board
Stuart
should be over Sat if I can park near enough I can only do about 20 yards
Stilldrillin:
Mentioning magic smoke........
Was doing a bit of roughing this afternoon......
Not very big licks......
5" dia aluminium castings. 10 thou each pass. Approx 200/ 250rpm.......
Had to use a parting tool. All I'd got to pass over the o/d.
Never bogged down/ stalled. Seemed to be machining nicely.......
BUT..... I had that hot paint smell again! Just like a new car exhaust system....... :bang:
The motor was warm, only. Nothing else was hot. Anyone any ideas?
David D
John Swift:
Hi Dave ,
all being well its just the lacquer on the new motor or the horse power resistor running hot the first time
one thing to look at could be the 1/4" lucar push-on connectors
if the are like the ones on my CL300M lathe they don't grip very well once you disturb them
I replaced them with new ones make from thicker brass
John
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version