Gallery, Projects and General > Project Logs
DIY laser cutter/engraver
<< < (2/4) > >>
DICKEYBIRD:

--- Quote from: Da_Kengineer_Meister on May 06, 2011, 05:16:21 PM ---I have considered a rebuild on this machine to pull out the built in controller a convert it over to a more generic controller so that it is closer to the CNC controlls that I am used to.  That or I may throw a digital logic analyzer on the USB stream, reverse engineer the messaging protocol and write a driver for this machine to interface it to some other existing software.  
--- End quote ---
OK, there's tonight's project but what would you do to keep yourself busy tomorrow night?  We wouldn't want you to get bored, eh?  :lol:

(Sorry for the hijack j45.)
Dave Sohlstrom:
Ken

Is that $475 for the whole machine or just the laser. Who is the supplier looks different than the 2x.

Dave
j45on:
Kenneth
If you are planning on rebuilding your laser  :hammer:
Bart the guy who designed the 2.X laser has a kickstarter project going for a linear bearing system that may be of interest you ?
http://www.kickstarter.com/projects/93832939/makerslide-open-source-linear-bearing-system


j45on:
I have a big box of Misumi frame extrusion  :ddb:
Each piece is cut to length and wrapped better than xmas presents
Also in the box is loads of corner brackets and t-nuts



This will be used to assemble the main chassis,lid and moving gantry of the laser cutter

j45on:
I finally got around to making a start today  :poke:

This what I have so far



I have a long weekend (4 days) off so I hope to get some more done :hammer:
Navigation
Message Index
Next page
Previous page

Go to full version