Gallery, Projects and General > Project Logs
Hit n Miss Engine ,,,,to MR D Kerzel's design
lordedmond:
Kenneth
It a wobbler ( sprung loaded center ) held by the TS and the dial gauge is used to check the run out )
Basically its a centre finding device to set thing running true
But I bet Rob can explain it better
Rob.Wilson:
Hi Ken
I can see how the photo is misleading :doh: ,,,,,,,,,,,,,, i had done a video to show it in operation to :( ,,,5 minutes until upload complete .
Rob
Rob.Wilson:
--- Quote from: craynerd on April 28, 2011, 08:22:47 PM ---
Just curious, what determines whether you choose to use your horizontal setup or a standard vertical? - I know there is always more than one way "to skin a cat", but just curious how you personally decide.
Chris
--- End quote ---
Hi Chris ,,,,,,,,,,,, i mainly just use the HZ for profile cutters , gear cutting and deep slots :dremel: :)
Rob
Rob.Wilson:
I am just as crap with video as i am with photos ::) ,,,,, but you get the idea :dremel:
Rob
saw:
This was wery intressting thanks for showing Rob.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version