The Shop > Our Shop

mill stand

(1/1)

marky123:
Hiya
Not plumb,not pretty but fixed,bolted and level.Cost was a few welding rods, 2 masonry drill bits, a couple of Rawlbolts and a tenner for a bit of plate.
Dug out of a field

chopped and shopped

I gave up on bolting it to the floor,so I dropped some studding in the rawlbolt holes and fixed it with some molten lead.
I also dropped a paving slab in the bottom to give it a bit of extra mass,hopefully to dampen any wobbles that may occur.
Need some clamps and Tnuts now!!!!
MARK

Rob.Wilson:
Nicely done Mark  :thumbup:


Good bit of recycling  :med: :clap: :clap: :clap:


Rob

Stilldrillin:
I like to see something/ anything given a new life, Mark.  :thumbup:

Well done!  :clap: :clap:

David D

Navigation

[0] Message Index