| The Shop > Our Shop |
| mill stand |
| (1/1) |
| marky123:
Hiya Not plumb,not pretty but fixed,bolted and level.Cost was a few welding rods, 2 masonry drill bits, a couple of Rawlbolts and a tenner for a bit of plate. Dug out of a field chopped and shopped I gave up on bolting it to the floor,so I dropped some studding in the rawlbolt holes and fixed it with some molten lead. I also dropped a paving slab in the bottom to give it a bit of extra mass,hopefully to dampen any wobbles that may occur. Need some clamps and Tnuts now!!!! MARK |
| Rob.Wilson:
Nicely done Mark :thumbup: Good bit of recycling :med: :clap: :clap: :clap: Rob |
| Stilldrillin:
I like to see something/ anything given a new life, Mark. :thumbup: Well done! :clap: :clap: David D |
| Navigation |
| Message Index |