| Gallery, Projects and General > How do I?? |
| How to deal with rust??? |
| << < (4/5) > >> |
| MadNick:
Afternoon, Ive got a lathe chuck that seems to be suffering. I take it any of the suggestions in this thread are equally applicable? Nick |
| sparky961:
To add my two cents, after cleaning up the part using one of the many methods described, I find that sticky chainsaw bar oil works very nicely to seal the surface. Even after wiping a lot of it off, there's still a protective residue left. Mix with your lighter oil of choice if you find it too sticky. Yes, it is messy but it does work. A better solution is to keep water from condensing on the metal by controlling the air/metal temperature. Do not use transmission fluid. In my experience, it seems to be hydroscopic (draws in moisture and retains it) and will actually cause MORE rust. -Sparky |
| Tony Wells:
5:1 water:Molasses and a little time. Good old timers method. |
| Stilldrillin:
--- Quote from: MadNick on January 19, 2012, 09:33:00 AM ---Afternoon, Ive got a lathe chuck that seems to be suffering. I take it any of the suggestions in this thread are equally applicable? Nick --- End quote --- Whichever method suits you, Nick! :scratch: Did anyone else in the UK notice the state of their machinery a couple of days back, as the weather warmed? Mine was covered in heavy condensation. :bang: :bang: Thank goodness for a WD40 regime, at each knock off....... :thumbup: David D |
| SwarfnStuff:
Just to reinforce Tony Wells' tip. Here in OZ there is a chap who restors old paddle steamers and engines. He uses Molasses:Water 1:10, Tosses the parts in for about a week. Guess the 1:5 might be a bit quicker. A non toxic, safe method and yes, he is an "Old Timer" |
| Navigation |
| Message Index |
| Next page |
| Previous page |