| The Shop > Metal Stuff |
| New Furnace Build ,,, Cupola |
| << < (15/32) > >> |
| krv3000:
can rost sum nuts with that rob well dun |
| vtsteam:
--- Quote from: krv3000 on May 27, 2013, 03:28:08 PM ---can rost sum nuts with that rob well dun --- End quote --- LOL, LOL! Lets hope not.... |
| Rob.Wilson:
Thanks Lads :beer: Only had an hour in the shop tonight so I decided to make the shoot ,were hopefully molten iron will flow from . So I grabbed an off cut of 100mm box . Set it at an angle I was happy with and marked both sides with chalk . A couple of minutes with an angle grinder . so I now had a shoot shape . I decided to bend out the sides using a 2ft adjustable. Once I was happy with the angle , mark one eye ball . I needed to bend the other side the same , the original measurement between the walls was 90mm I had bent the first side out 20 mm so all i had too do was bend the other out until the gap was 130mm then both would be bent equal , well close enough for this job. the bit scrap that was cut from the box previous was re welded in at the front for the shoot to form a lip. The shoot was then welded to the drop bottom . would have took me 40 minutes if I did not stop to take photos :lol: :lol: :lol: Cheers Rob |
| hermetic:
Superb piece of work, Get yersen a broon! Phil. |
| tekfab:
Is this an Australian Cupola ? :D |
| Navigation |
| Message Index |
| Next page |
| Previous page |