The Shop > Metal Stuff
New Furnace Build ,,, Cupola
Rob.Wilson:
--- Quote from: awemawson on June 09, 2013, 03:48:33 PM ---Conventional advice is if you must use a tool post grinder, cover the ways in damp newspaper first, then after use, a good clean up and re-oil. Grinding grit trapped under a way wipe can cause no end of damage.
--- End quote ---
Sound advice Andrew :thumbup:
I had the shop vac stuffed between the ways :dremel:
Rob
Mayhem:
Better pull your finger out Rob - Steve is talking about mixing mould sand in his build :whip:
vtsteam:
Talk is cheap. :zap: Raining again today can't even mix the stuff. Rain through to weekend predicted :bang:
Last two years: drought. Can't complain.
Rob.Wilson:
--- Quote from: Mayhem on June 13, 2013, 09:02:04 AM ---Better pull your finger out Rob - Steve is talking about mixing mould sand in his build :whip:
--- End quote ---
:lol: :lol: Aye Steve is kicking my butt , I have been rather distracted this week , work , new shop toys , just picked up a load of blacksmiths gear yesterday :hammer: I am fighting the urge to knock up a forge :lol: :lol:
Rob
Mayhem:
--- Quote from: RobWilson on June 16, 2013, 03:48:36 AM ---
--- Quote from: Mayhem on June 13, 2013, 09:02:04 AM ---Better pull your finger out Rob - Steve is talking about mixing mould sand in his build :whip:
--- End quote ---
:lol: :lol: Aye Steve is kicking my butt , I have been rather distracted this week , work , new shop toys , just picked up a load of blacksmiths gear yesterday :hammer: I am fighting the urge to knock up a forge :lol: :lol:
Rob
--- End quote ---
New shop toys you say? Do show :drool:
Did you see the forge I made from an old Landcruiser rim?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version