| The Shop > Metal Stuff |
| New Furnace Build ,,, Cupola |
| << < (23/32) > >> |
| Rob.Wilson:
--- Quote from: awemawson on June 09, 2013, 03:48:33 PM ---Conventional advice is if you must use a tool post grinder, cover the ways in damp newspaper first, then after use, a good clean up and re-oil. Grinding grit trapped under a way wipe can cause no end of damage. --- End quote --- Sound advice Andrew :thumbup: I had the shop vac stuffed between the ways :dremel: Rob |
| Mayhem:
Better pull your finger out Rob - Steve is talking about mixing mould sand in his build :whip: |
| vtsteam:
Talk is cheap. :zap: Raining again today can't even mix the stuff. Rain through to weekend predicted :bang: Last two years: drought. Can't complain. |
| Rob.Wilson:
--- Quote from: Mayhem on June 13, 2013, 09:02:04 AM ---Better pull your finger out Rob - Steve is talking about mixing mould sand in his build :whip: --- End quote --- :lol: :lol: Aye Steve is kicking my butt , I have been rather distracted this week , work , new shop toys , just picked up a load of blacksmiths gear yesterday :hammer: I am fighting the urge to knock up a forge :lol: :lol: Rob |
| Mayhem:
--- Quote from: RobWilson on June 16, 2013, 03:48:36 AM --- --- Quote from: Mayhem on June 13, 2013, 09:02:04 AM ---Better pull your finger out Rob - Steve is talking about mixing mould sand in his build :whip: --- End quote --- :lol: :lol: Aye Steve is kicking my butt , I have been rather distracted this week , work , new shop toys , just picked up a load of blacksmiths gear yesterday :hammer: I am fighting the urge to knock up a forge :lol: :lol: Rob --- End quote --- New shop toys you say? Do show :drool: Did you see the forge I made from an old Landcruiser rim? |
| Navigation |
| Message Index |
| Next page |
| Previous page |