Gallery, Projects and General > How to's
Home Workshop Milling Feeds and Speeds
Stilldrillin:
Spot on Dave! :clap:
Thank you. :thumbup:
My pal left here yesterday, taking my old mini mill with him. Going to pm him now...... :D
David D
wongster:
I've been looking for this!!! Thank you, Dave.
Will be sharing with my little group in Singapore. Some of us have been trying different combinations till we snapped the cutter.
Best regards,
Wong
Rob.Wilson:
Good post Dave , well posted info :thumbup: :clap: :clap: :clap: :clap:
Rob
doubleboost:
That was a very well written post. :thumbup: :thumbup:
I think some of it may have sunk in . :) :)
AcieraF3:
Thanks Dave,
You re-assured me in my more or less intuitive approach to speeds and feeds. If it sounds right and it looks right it probably is right!
Teun
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version