Gallery, Projects and General > Gallery
Harold Hall's precision grinding table
sbwhart:
Nice neat bit of maching there Bob :thumbup:
Stew
Rob.Wilson:
Very nice Bob :clap: :clap: :clap: :dremel:
Rob
Bernd:
Lookin' good Bob. :thumbup:
Bernd
xo18thfa:
Thanks fellas. The table itself is all done and ready to install. My beautiful wife has given a "green light" to a new grinder. :D :D
The grinder and table will either get mounted on a steel plate, or a piece of granite counter top I found on a junk pile. Decided to take the handles off and use hex nuts. The last part in Mr Hall's plan is a "cheater bar" to tighten the handles. May as well just use a wrench.
xo18thfa:
Finally got the Harold Hall grinding table installed and running. It's nice, I like it. The wheel is all trued up with a diamond point dresser. It runs smooth as a baby's butt. Got all new HSS lathe tools and we are cutting serious steel now.
Also made the drill bit grinding attachment. It works very nice. It cuts a razor sharp 4 facet edge. I have a bloody finger to prove it.
I am glad I did this project. It's a great addition to the shop.
Next up, a Harold Hall dividing head.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version