The Shop > Electronics & IC Programing
DRO questions
j45on:
Cheers Andy I shall keep that in mind :thumbup:
I am having trouble with scales though,I have wired one up to test and it was working fine with a battery but wont work without one :scratch:
I have a 100uF electrolytic with a .01uF ceramic in parallel as mentioned by Tumutbound
:doh: Looks like I forgot to add some jumpers ( i wondered what they were for :palm: )
tumutbound:
--- Quote from: andyf on April 22, 2011, 09:47:32 AM ---
Not that I want to discourage you, but in MEW issue 111 (Dec 05/Jan 06) there's Part 1 of a series about using chinese calipers and the Shumatech 350 readout.
The author said: "I found my 4 pin DIN plugs and sockets on the back of the DRO a nightmare to solder up. [They] just have solid pins to solder to. A type with solder buckets would have been easier with less possibility of solder bridges."
--- End quote ---
I got rid of the DIN plugs and used 4 pin microphone plug/sockets similar to these.
Much easer to solder and as they screw together, no chance of scales becoming disconnected.
SPiN Racing:
Gereat thread everyone. A lot of questions I had.. but hadnt formulated have been clarified, and answered.
An example.. why get the small digital chinese ones.. but now I understand much better how they work, and how the DROs work with them.
:mmr:
Navigation
[0] Message Index
[*] Previous page
Go to full version