Gallery, Projects and General > Project Logs
My Kwackers RT controler
<< < (3/4) > >>
philf:
Re: XLR connectors.

For my CNC conversion project I bought 4 decent quality latching XLR plugs and sockets from www.audiospares.com. Including postage and VAT they were only £16.06. Part numbers are AS-CO-P-XLRM4 (XLR 4-Pin Male Connector)  & AS-CO-S-XLRF4 (XLR 4-Pin Female Chassis Socket).

Phil.
cfellows:
Is there a link to a website for the Kwakers RT controller?

Chuck
HS93:
try this
http://madmodder.net/index.php?topic=2242.0

http://www.cnczone.com/forums/open_source_controller_boards/47007-rotary_table_indexer-32.html#post366777

Peter
Chuck in E. TN:
I just ordered a Vertex 4" Rotary Table and intend to follow kwackers controller build also.

Chuck in E. TN
Chuck in E. TN:
I hope it's o.k. to resurect this thread. I am building the kwackers controller for my Vertex RT, but haven't worked on it in a while.
My issues are with making the pcb. I have not been able to get a good transfer of the layout, using the laser toner/iron on transfer method, to etch the board. Is there a source for a pre-made circuit board for this project?
Can I beg someone to make a board for me?
If I should have started a new thread, would one of the moderators move this post, please?

Chuck in E. TN
Navigation
Message Index
Next page
Previous page

Go to full version