Gallery, Projects and General > Gallery

HOT ROD OIL CAN

(1/2) > >>

krv3000:
HI all befor i start for give spelling   right i have one of thows anoying oil cans that will not stand up so i have modifid the one that i had for this job you will need a 250ml pant tin lid sed oil can plumers flux soft rolder two types if you have it ie hi and lo melting point disisembel the oil can and remove all the pant and give the bace a good kleen with emry cloth yous hi melting pont to tin the botom of the can kleen the pant tin lid i did this by soking the lid in thiners tin the under side of the pant tin a gane with hi melting pont solder  place the lid on a thermel block place the oil can in the center and even the gap all a rawnd the oil can  place a hevey wate on top of the oil can to keep it prest furmley in to the pant tin lid then with a blow torch swet the two together and fill in the gape a rawnd the oil can then leev to cool once cool  tip the jobe over and fill in the bace with lo melting pont solder if you onley have lo melting pont solder rap awet cloth a rawnd the botom of the oil can befor turning over  once all the soldring is dun dres  the ruff bits with a file  repant put the oil can back together  you will never knoc it over a gane right pics     :ddb:

krv3000:
pics

krv3000:
pic

krv3000:
pic

bigmini:
That's a great fix for a really annoying problem. :beer:

Navigation

[0] Message Index

[#] Next page