| Gallery, Projects and General > Project Logs |
| Simple beginner project - faceplate dogs |
| << < (4/5) > >> |
| krv3000:
A nuther one for me to do well posted :nrocks: |
| AndyB:
Bugger! :( That's what I needed to hold the aluminium cylinder for my Rider Ericsson. I had heard of them but couldn't figure out how to make them!!! :doh: Thank you very much, right up there on the to-do list! :clap: Andy |
| BK:
Umm, looks like something else to make, they would come in very handy. :thumbup: |
| Andrew_D:
Might I offer one piece of advice?? Before the ends of the set screws mushroom out and you can't remove them, turn the threads off or turn a point or something! Been there before!!! Andrew |
| bigmini:
--- Quote from: Andrew_D on February 22, 2011, 08:38:44 PM ---Might I offer one piece of advice?? Before the ends of the set screws mushroom out and you can't remove them, turn the threads off or turn a point or something! Been there before!!! Andrew --- End quote --- That's a good idea. I've thought about putting a point on them having already turned down the heads to make them fit in an 8mm hole. I'll probably do that next. They're intended to be used up against the work with only a small amount of the set screw protruding for maximum stability. |
| Navigation |
| Message Index |
| Next page |
| Previous page |