Gallery, Projects and General > How do I??

Draw Bar T-Wrench?

<< < (3/3)

Swarfing:
Rikk those that never do anything wrong never did nothing. You only learn from mistakes so just tell yourself it just cost you a lesson. I've spent a fortune on lessons myself  :)

Rikk:
I do enjoy learning by doing, but if you'd of seen me at the start squaring off a bit delrin with a 16mm 2 flute cutter, taking a .1mm cut and turning the feed as slooooow as possible as I had no idea. Took me bloody ages to do anything, now I know much better about feeds and speeds I can't turn the handle fast enough with the same cutter at any cut depth in delrin and not far off in ali 8)

Navigation

[0] Message Index

[*] Previous page