« previous next »
Pages: [1]   Go Down

Author Topic: Hello from Herne Bay, Kent.  (Read 5470 times)

Offline tonybraz

  • Jr. Member
  • **
  • Posts: 14
Hello from Herne Bay, Kent.
« on: February 02, 2011, 12:40:24 PM »
I been reading the site for a few weeks and decided to join. I race cars full size (750 Formula) and model cars (not as fast as the kids).Workshop at the bottom of the garden has a Weiler LZ280,Tom Senior mill and a small cnc mill.

Tony
Logged

Offline j45on

  • Sr. Member
  • ****
  • Posts: 380
  • My tiny workshop Location Ashford Kent
Re: Hello from Herne Bay, Kent.
« Reply #1 on: February 02, 2011, 01:43:33 PM »
Hi Tony  :wave:
Logged
Jason

Offline Brass_Machine

  • Administrator
  • Hero Member
  • *****
  • Posts: 5534
  • Country: us
Re: Hello from Herne Bay, Kent.
« Reply #2 on: February 02, 2011, 02:01:39 PM »
Hiya Tony  :wave:

Welcome to the collective :borg:

Show us pictures of the race cars!

Eric
Logged
Science is fun.

We're all mad here. I'm mad. You're mad.

Offline krv3000

  • Hero Member
  • *****
  • Posts: 2188
  • Country: gb
Re: Hello from Herne Bay, Kent.
« Reply #3 on: February 02, 2011, 05:45:54 PM »
HI jump in and have fun    :nrocks:
Logged

Offline saw

  • Hero Member
  • *****
  • Posts: 1003
  • Country: se
  • lucky amateur
    • Svenssons AckordsWerkstad
Re: Hello from Herne Bay, Kent.
« Reply #4 on: February 02, 2011, 06:22:42 PM »
Welcome Tony  :wave:
Logged
_________________________
Greetings / Benni
http://myprojecty.wordpress.com/category/steam-engine/

Offline tonybraz

  • Jr. Member
  • **
  • Posts: 14
Re: Hello from Herne Bay, Kent.
« Reply #5 on: February 04, 2011, 05:27:30 PM »
 
   hear is a picture of my workshop, a little hard to zoom the camera to get a good picture will try another camera

   Tony
Logged

Offline Ray

  • Jr. Member
  • **
  • Posts: 95
Re: Hello from Herne Bay, Kent.
« Reply #6 on: February 04, 2011, 08:46:41 PM »
Welcome Tony. 
Ray
Logged
Waco, Texas

Offline tonybraz

  • Jr. Member
  • **
  • Posts: 14
Re: Hello from Herne Bay, Kent.
« Reply #7 on: February 05, 2011, 04:48:33 PM »

  A few more pictures of the mill, the is a compucutters design. I run it on Mach3 and am thinking of buying Cambam. The spindle motor is a brushless motor 800kv running on 15 volts and this has enough power to run a 6mm cutter with stallling.

  Tony
Logged
Pages: [1]   Go Up
« previous next »