| Home Base > Introductions |
| Hello from Herne Bay, Kent. |
| << < (2/2) |
| tonybraz:
hear is a picture of my workshop, a little hard to zoom the camera to get a good picture will try another camera Tony |
| Ray:
Welcome Tony. Ray |
| tonybraz:
A few more pictures of the mill, the is a compucutters design. I run it on Mach3 and am thinking of buying Cambam. The spindle motor is a brushless motor 800kv running on 15 volts and this has enough power to run a 6mm cutter with stallling. Tony |
| Navigation |
| Message Index |
| Previous page |