Gallery, Projects and General > Project Logs

Little Kathy and me

<< < (5/11) > >>

Dean W:
Once again, it's looking good Benni. 
It appears to use a great big valve compared to others this size.

Trion:
Mycket bra! Looking forward to the next post!

Rob.Wilson:
Nice work Benni  :thumbup: :clap: :clap: :clap: :clap:


Rob  :)

saw:
Hello gent and thanks for kind words.  :thumbup:
Dean W: this steam engine has an valvet chamber, a cylinder not done yet, and inside a round valve is connected. Thats why it is rada big.

Ok the story goes on.
It’s time for the bottom cover it’s a little bit tricky as you can see on the plan.

On the upper side it should pass the inside of the cylinder, to the left a hole for the column and to the right two holes for the other column.
On the bottom side a center hole for the piston rod. But as you can see  there is no steam packing so I decided to modified little Kathy a bit.
First some turns in the lathe for the piston road.

Then I make the steam packing.

The top side passing for the cylinder.

Then drilling for the column.

Drilling and threading for the cylinder.

Assembling the parts so far.

I am still waiting for some equipment so I have to do this small work wail I am waiting.
I’ll be back  :wave:
Benni

NickG:
Benni,

It's all looking very good to me. Did you use a die on that packing gland thread or screwcut?

Nick

Navigation

[0] Message Index

[#] Next page

[*] Previous page