The Shop > Tools
Scrap Yards
CrewCab:
Mr Stevenson :thumbup:
Blimey is nowhere sacred :D ................ welcome aboard Sir 8)
CC
Darren:
Part tiled the new bathroom floor today,,,oo,ps sorry wrong forum ;D
Well apart from that I stripped the compound slide on the Smart and Brown to check if all was the same there regarding the screw.
Alas it's not, same design totally, except it's a left hand thread, so one right and one left...
Ho hum, more tools to buy then......and I need a 3/8 die too or do it on the mini.....but that's no issue really.
Darren
CrewCab:
--- Quote from: Darren on November 16, 2008, 03:43:19 PM ---Part tiled the new bathroom floor today
--- End quote ---
No worries Darren, I (think) I finished the kitchen tiling today :beer:
just don't ask in which decade I started it ::)
CC
dsquire:
CC
What Century did you start it??? I just had to do it.
:beer:
Don
Darren:
Another update, decided to do a little more on this last night.
Well my ER32/MT3 collet holder and a set of collets turned up. You know how it goes, new toy and all that.
Still only armed with some new 5mm end mils I set about a little end facing and cutting a slot.
I needed a flat on one side of this disk
Finished off
Now the slot
And finally a little marking out followed with 3 center punch marks ready for drilling.
Well that was enough for one nights relaxation therapy.. :wave:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version