| The Shop > Tools |
| Scrap Yards |
| << < (7/9) > >> |
| CrewCab:
Mr Stevenson :thumbup: Blimey is nowhere sacred :D ................ welcome aboard Sir 8) CC |
| Darren:
Part tiled the new bathroom floor today,,,oo,ps sorry wrong forum ;D Well apart from that I stripped the compound slide on the Smart and Brown to check if all was the same there regarding the screw. Alas it's not, same design totally, except it's a left hand thread, so one right and one left... Ho hum, more tools to buy then......and I need a 3/8 die too or do it on the mini.....but that's no issue really. Darren |
| CrewCab:
--- Quote from: Darren on November 16, 2008, 03:43:19 PM ---Part tiled the new bathroom floor today --- End quote --- No worries Darren, I (think) I finished the kitchen tiling today :beer: just don't ask in which decade I started it ::) CC |
| dsquire:
CC What Century did you start it??? I just had to do it. :beer: Don |
| Darren:
Another update, decided to do a little more on this last night. Well my ER32/MT3 collet holder and a set of collets turned up. You know how it goes, new toy and all that. Still only armed with some new 5mm end mils I set about a little end facing and cutting a slot. I needed a flat on one side of this disk Finished off Now the slot And finally a little marking out followed with 3 center punch marks ready for drilling. Well that was enough for one nights relaxation therapy.. :wave: |
| Navigation |
| Message Index |
| Next page |
| Previous page |