| Gallery, Projects and General > Project Logs |
| Webster IC Engine build log. |
| << < (19/69) > >> |
| raynerd:
--- Quote from: sbwhart on February 17, 2011, 03:58:46 PM ---Nice gear Chris well done. That tamed the beast :whip: Stew --- End quote --- Cheers Stew - it took two years of taming before I`ve been able to manage cutting a gear all on my own :coffee: |
| scrapman:
Great job Chris :clap: Ray. |
| raynerd:
Slow slow slow going.... I cheated, I purchased the second gear a 24 tooth 32DP off ebay for no more than £3! It is nice to see that my 32DP 48 tooth gear meshes with it so it was a success!! I`ve tapped the cylinder which was tought and it fits nicely into the cylinder support. I`ve not got any nice cap head screws to fit so the screws in the photo are just temporary. I`ve also bolted the supports to the base piece and I`ve drilled them to fit the bearings. I`ve gone with bearings intead of bushes. |
| raynerd:
Could anyone help me with reading the plans!! http://home.comcast.net/~webster_engines/Plans.zip Page 7 of 21 The wrist pin! I really don`t understand any of it - I literally can`t see how it should look and can`t read the plans at all. I expected the wrist pin to be simply a pin, maybe a slight taper that pushes through the piston to attach it to the con-rod. I`m sorry, feel a bit of an idot but I just can`t make it out!! I`ll update with some pictures too soon! Not done much as I`ve had a busy month at work and home but I`ve now done the con rod! Any help much appreciated! |
| ieezitin:
Chris. Looks like there milled flats down .010 thou deep x .219 in from both ends, with a .094 bore through the pin x .188 od. It has a .015 flat 45* chamfer each end. Anthony. |
| Navigation |
| Message Index |
| Next page |
| Previous page |