Gallery, Projects and General > Gallery

Electronic leadscrew attachment

<< < (2/3) > >>

picclock:
The caliper information is read directly into the microprocessor, and sadly (I have no life) I programmed it in assembler using MPLAB  :loco:

Cos it started out being a lot simpler and grew. If I had known what it would become I would have used C and saved quite a few hours.

Glad you found it of interest.

picclock

DavidA:
Hey,  I have MPLAB.  all I need to do now is learn how to use it and then I can set about re-programming my temperature logger to sample every minute instead of every second.

It won't be this year though.

Dave.

Jonny:
Excellent stuff shouldnt be too hard to use for thread cutting.
May be a market for those without gear boxes!

Brass_Machine:
Plenty of interest here. I would like to here more about it. Going to take a look at your link.

Eric

HS93:
Very nice two things where did you get the stepper driver  link.. and the key board looks very profesional how was that done in fact any chance of a build discription as I think a lot of people may be interested.

Peter

Navigation

[0] Message Index

[#] Next page

[*] Previous page