Gallery, Projects and General > Project Logs

Potty Over Crank Wall Engine

<< < (25/71) > >>

raynerd:
It is looking great Stew!

Chris

saw:
Very nice good work  :clap: :clap: :thumbup:

spuddevans:
Not long to go now, looking really good  :thumbup: :thumbup:

Tim

sbwhart:
Thanks Chaps, must admit I'm getting quite excited at the prospect of trying to get it to run.

Bit more progress this time with the base:- cut the jig plate to size and squared up the edges.

Then drilled the fixing holes and dowel holes for the bearing housings, and clearance for the crank throw



Assembled the bits to the base this gave me the first chance to see if it turned over OK so put a couple of nuts on the crank and wound it over with a spammer,  :D (if only) and it turned over fine.



Next up I need to fit the bearing strips for the slide bars.

I guess another couple of weeks and we will see if it will run.

Stew

NickG:
It's looking brilliant that Stew. It's going to develop quite a lot of power!

Navigation

[0] Message Index

[#] Next page

[*] Previous page