| The Shop > Our Shop |
| My dump! |
| << < (5/6) > >> |
| latheman:
Hi frogsuk, Now, I could spend lot's of time putting stuff on this forum here. Alternatively, and I think this is probably better, we could communicate via personal messages. So, I've put a test message out to you. So if you've received it, then a quick reply to signify. I have all the original advertising from Warco which may be of use, otherwise ask whatever you want and I'll try to answer. I'm usually on most days. Regards, Peter |
| frogsuk:
Thank you Peter... I got the test messages and will PM later with my questions Kind Regards Mike Inglis |
| deepstar:
Hi folks, hi is there any chance you have a parts manual for your warco 220 lathe ??? any chance o fa copy regards bill |
| frogsuk:
Sorry I dont have one... What has gone wrong? |
| S. Heslop:
About the flash thing. It's a common cheap trick to make a flash diffuser/ bouncer for built in camera flashes by taking an empty cigarette pack and reversing the foil inside so the shiny side faces in, then plopping that over your camera flash. The intense light then bounces through it. It's used to make the flash softer with less hard edges (without buying expensive fancy equipment), or at least I think it is. I was a bit of a failed photographer... But it should get the flash up and over the large wide angle lense. |
| Navigation |
| Message Index |
| Next page |
| Previous page |