The Shop > Our Shop

Photo of my workshop

<< < (2/2)

Jonny:
Always interested in these Lux type mills and did plan on a partial strip down over Christmas.
Lower spindle bearing has play, an off the shelf item cheap but wanted to see if theres a way to beef up the spindle and use faster speeds above 2k.

Rarely break cutters unless i have power feed on with smallish cutter doing slots.
Was also going to knock up a quick change draw bar.

Seen these DRO just fitted two to the M300 trouble is would cost £236 for X axis on Lux.
http://www.machine-dro.co.uk/index.php?target=products&product_id=346
http://www.machine-dro.co.uk/index.php?target=products&product_id=347
http://www.machine-dro.co.uk/index.php?target=products&product_id=350

So much can be done to improve or aid use of these machines.

I havent the room for a 942 or 836 without sacrificing valuable work area.

Navigation

[0] Message Index

[*] Previous page