| The Shop > Our Shop |
| Photo of my workshop |
| << < (2/2) |
| Jonny:
Always interested in these Lux type mills and did plan on a partial strip down over Christmas. Lower spindle bearing has play, an off the shelf item cheap but wanted to see if theres a way to beef up the spindle and use faster speeds above 2k. Rarely break cutters unless i have power feed on with smallish cutter doing slots. Was also going to knock up a quick change draw bar. Seen these DRO just fitted two to the M300 trouble is would cost £236 for X axis on Lux. http://www.machine-dro.co.uk/index.php?target=products&product_id=346 http://www.machine-dro.co.uk/index.php?target=products&product_id=347 http://www.machine-dro.co.uk/index.php?target=products&product_id=350 So much can be done to improve or aid use of these machines. I havent the room for a 942 or 836 without sacrificing valuable work area. |
| Navigation |
| Message Index |
| Previous page |