| Gallery, Projects and General > Project Logs |
| Stuart No 4 Build |
| << < (3/3) |
| kwackers:
Hi Madjack - bore and stroke are 1.5" x 1.5" @cidrontmg, I dropped lucky with my castings, I picked up 2 sets from the local engineering club for 50ukp each(about $75), both sets were unmachined and both had two sets of piston rings each but given their history I can't say how old they were (one set at least looked to be 20 years or so old). I've done some more work on the reversing gear but I'm on hols at the mo so will post pics when I'm back and have a bit more done. The eccentric was giving me some grief, the material is supplied as two pieces - neither of which is big enough to make the pair as one unit, but the plans show it as one unit... Whilst I could make it in two pieces there's no obvious way the (cast iron) parts could be joined to make a single unit! If I don't figure it out then expect a post asking for help... :scratch: |
| Stilldrillin:
Hi Steve. That's big.... And very nice! :D Good luck with the rest of the build. :thumbup: David D |
| Navigation |
| Message Index |
| Previous page |