Home Base > Introductions

Lurker breaks cover

(1/4) > >>

benji:
 :wave:
Hi folks, thought I'd pop my head up and say hello, I've only been lurking here for about 12 months.
I'm Mark, currently living in Cumbria England (where men are men and sheep are scared). My main interests are Land Rovers, I have and ex military air portable that is undergoing major surgery, and classic tractors, the fleet includes a  Grey Fergie, a Leyland 2100 with a McConnel digger on it and a Ford 3910h. I'm of the opinion that a man can never have too many toys.

Workshop wise I have an Axminster BV20 lathe (not brilliant but when I got it, it was the best compromise available) a Weiss WMD30 milling machine which I think is great. I also have a skip rescued Perfecto 3.5" lathe and a Raglan mill that some one had cut in half and then put a 35mm spacer made out off thin wall square tubing. Both of these are undergoing "remedial" work.

Slowly working my way through a Stuart 10v

Emmmm, I currently work as an IT technician for a large agricultural/motor dealership group, prior to that I ran the Land Rover parts department for the same group.

Not a lot more to say at the moment, other than once again Hi!  :wave:

raynerd:
Hi Benji!

Welcome  :wave:

The forum would welcome another 10V build, there are a couple being built in the project forum at the moment!

Chris

spuddevans:
Hi Benji  :wave: welcome to the club.


Tim

scrapman:
Hello Benji  :wave: welcome to the forum a great and friendly place,


Ray.

benji:
Thanks for the welcome guys.

I've been following Chris and Ray's threads, I must say I'm impressed. Hopefully mine will be as good as yours. I'll start a build log when I've taken a few piccies.

Mark

Navigation

[0] Message Index

[#] Next page