The Breakroom > The Water Cooler

What can freebie be used for?

<< < (3/4) > >>

Bogstandard:
Don't I know it Ralph.

I had a few of the members over on Saturday, and I thought I would turn the heater up in my shop a bit in the morning. Got in there on Sunday, and it was +1 deg C, normally 15 degs. I had turned the thermo the wrong way, I am now waiting for it to get up to temp again to do a bit of work in there.  :doh:


John

AdeV:
I went in there to machine a block of mumblteel (it's covered in yellow paint, it could be anything), but I noticed the lathe was chattering. I tried the mill, but that was chattering too. Same with the saw.

Confused the hell out of me.

Then I realised it was my teeth, so I got the hell out of the workshop & started playing with the soldering iron instead, in the nice warm office... Aaah, heat...

Stilldrillin:
Few mins in the shop, this aft. Digital thermometer shows 8 dgrs.... Not too bad!

Closer look.......Noooo! .8 dgrs!  :bugeye:

Got back inside the house, quick!  :thumbup:

David D

Bluechip:

--- Quote from: Stilldrillin on November 30, 2010, 04:00:02 PM ---Few mins in the shop, this aft. Digital thermometer shows 8 dgrs.... Not too bad!

Closer look.......Noooo! .8 dgrs!  :bugeye:

Got back inside the house, quick!  :thumbup:

David D



--- End quote ---

0.8 degrees ?? Near enough horizontal for a Mamod owner, I should think  :lol:

BTW  DVD's lurking on table, awaiting dispersal of local Yetis ..

Dave BC

Dave BC

Stilldrillin:
Horizontal Yetis no problem here Dave!  :thumbup:

David D

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version