| Gallery, Projects and General > Project Logs |
| stuart 10v build |
| << < (2/23) > >> |
| scrapman:
Thank you for the comment Nick. Ray. |
| scrapman:
Well i have done a bit more on the engine today, Drilling the crankshaft bearings, Turning the bearing, drilling the bearing checking the bearings for fit, bearing fitted and tapped 1/8 x 40 for the oilers, all comments and advice would be appreciated, Ray. |
| Stilldrillin:
Looking good, and taking shape nicely Ray! :clap: :thumbup: David D |
| raynerd:
Ray.... friend..... slow down... this is not a race!! :lol: :lol: :lol: Well done Ray, you had the lovely situation of being provided with one piece for the bearings. I had two little pieces so drilling them aligned was hard work. Once the cylinder and covers are done you`ll be where I`m up to. :doh: ...anyway... no time to type! :dremel: |
| scrapman:
Made a start on the crank this evening, Chris, Congratulations on passing the foundation course, Thank you all for the comments , 73'S Ray MW0COE |
| Navigation |
| Message Index |
| Next page |
| Previous page |