| Gallery, Projects and General > Project Logs |
| Cylinder Puzzle - Finished Weekend Project! |
| << < (14/17) > >> |
| raynerd:
Probably my poor effort of a drawing but it should relate to the fact that the hole is higher than the centre of the groove and ends about 1mm from where the lid is.... So in that picture, the hole should be end about 1mm from the shoulder of the lid. It is irrelevant really as long as the hole is high and not in the center of the groove. Hope that helps...as I said, just my poor effort of a drawing! Chris |
| boatmadman:
Chris, Thanks, the mist has lifted. :beer: Ian |
| KE5AFU:
Thought I would post with part 1 of my attempt at this puzzle. I was trying out live tooling with the lathe. |
| Pete.:
Show off :D |
| kwackers:
That's not a Drummond round bed is it?? |
| Navigation |
| Message Index |
| Next page |
| Previous page |