Gallery, Projects and General > Project Logs
Cylinder Puzzle - Finished Weekend Project!
AdeV:
They're computer drawings! You can tell because, in the 1st pic with the super-shiny items, there's no sign of the camera...
I must admit, though, they are extremely good renders. I am most impressed.
slowcoach:
Yep, all generated by computer. I just wish there was a key I could press, to convert them from the virtual world in to the real world :lol:
Cheers
Rob :thumbup:
boatmadman:
This is brilliant and I want to make one, but, how do you drill a semi circular hole?? :doh:
Majorstrain:
--- Quote from: boatmadman on November 16, 2010, 05:42:44 PM ---This is brilliant and I want to make one, but, how do you drill a semi circular hole?? :doh:
--- End quote ---
I transfered the piece to the mill and held it with a V block in the vice. Then I used a slot drill to do the holes.
I drilled the cap hole before parting it off so there was something substantial to grip in the V block.
Pics, when I get home later tonight.
Cheers,
Phil
raynerd:
Yep - the same. Used my new V-blocks :D and just held it in the vice on my mill. I only had an end mill so I went into it at full depth (5mm) very slowly until I took out the semi-circle for the hole.
AdeV - AMAZING !!! Haha, my wife has just taken a look at the red one with my name engraved and even she was blown away!
Chris
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version