| Gallery, Projects and General > Project Logs |
| Rider Ericsson Hot Air Engine |
| << < (2/17) > >> |
| Bernd:
--- Quote from: AndyB on November 07, 2010, 11:30:15 AM ---Got to bore it next. That will take some figuring out...as will figuring out how to put pictures in line with the text :scratch: :lol: --- End quote --- Andy, Your going to ned a place to store the photo's such as "photobucket", You'll need an account. I use my own web site to host the pictures. Also the pictures should be sized to about 600 X 800 pixels. These are then enbeded into the text with the "img" comand located in the upper left of the reply area. Also check the forum. I believe Ralph did a tutorial or write up on how to do all that. Can't remember exactly where that is located right now. Bernd |
| Brass_Machine:
--- Quote from: Bernd on November 07, 2010, 05:07:14 PM --- --- Quote from: AndyB on November 07, 2010, 11:30:15 AM ---Got to bore it next. That will take some figuring out...as will figuring out how to put pictures in line with the text :scratch: :lol: --- End quote --- Andy, Your going to ned a place to store the photo's such as "photobucket", You'll need an account. I use my own web site to host the pictures. Also the pictures should be sized to about 600 X 800 pixels. These are then enbeded into the text with the "img" comand located in the upper left of the reply area. Also check the forum. I believe Ralph did a tutorial or write up on how to do all that. Can't remember exactly where that is located right now. Bernd --- End quote --- Here ya go... Thread on posting pictures is HERE |
| Stilldrillin:
Hi Andy. I love those engines! All those moving levers etc They look alive when running....... :D Good luck with your clearances. Looking forward to further progress. :thumbup: David D |
| AndyB:
Great stuff! Thank you very much. :nrocks: It looks as if I will clamp the base to the vertical slide with straps then bore with an indexable boring head mounted in the headstock. Will have to back it with a plank of wood so that I don't bore through the vertical slide! :ddb: Off to the Federation of Harley Davidson Clubs of Europe President's Meeting this weekend so the next installment will be late I'm afraid. Andy |
| cidrontmg:
Lo AndyB, I once had a bit less clearance than you had, the workpiece was about 2 mm too long for the gap. :bang: I took an angle grinder, and ground 2 mm off the bedways of my Myford S7... :loco: Didnīt feel too good about it, but wtf... Worse things happen all the time... I havenīt noticed any deleterious effects about that open throat surgery anyhow. :wave: |
| Navigation |
| Message Index |
| Next page |
| Previous page |